Not too long I bought my first spinning wheel. I didn’t know enough about buying them at the time, but I was impatient and bought it anyway. It was a used wheel called a “Tom Thumb” which is from around 1980, made in New Zealand. It’s missing a few parts, most notably four knobs that match the two I have. One goes to the orifice hook, one goes to the second lazy kate, and the third goes to.. I can’t remember what. The maiden head was cracked and my husband managed to sand and repair it last year. We had intended on refinishing the entire piece and getting it running properly, but then kiddo made his early appearance and it got put aside.
I took it out today to give it a bit of love, shine it up and make sure she still runs (which she does). I have it set for double tension right now, but I need a piece to hold the footman to the wheel, I’m using a paperclip right now and lets just say it’s awkward. Ideally I’d like some sort of nut or bolt along with some felt so that the footman doesn’t rub and make a lot of noise (like it does now). I also bought a new orifice hook for it, it won’t match exactly, but that’s alright. In the meantime I set out to see if I could find a woodworker who could make matching knobs for me. I’d like to restore this wheel to her former glory, it’s an incredibly solid wheel that I’m sure has seen some good years.
Ideally, in the (far) future, I’d like to purchase a new wheel. Maybe an Ashcroft Traveller. I also own a few drop spindles (one wooden and two 3D printed) that are a lot of fun to use. In order to get better at spinning you need to practice practice practice practice – and I just haven’t had the time on top of everything else. If it’s a hobby you enjoy though, to make the time and find it some where. So that’s what I’ll do. You can see the yarn I’ve spun so far over on my Ravelry page – some people have amazing yarn. That’s the level I want to get to, and I will, with practice.